Planting into pallets

Is there anything you can’t make out of an old pallet? Yes, it does take more time and a bit more know-how to upcycle a pallet into a totally different and functional thing, but luckily I have an expert on my side. Yep, Joel does it again. This time he made me a new seed planting flat out of recycled pallet wood.

(Note: I do also do make these out new wood too, see here)

Cool Huh? Want to try? Here is how he did it.

First, he tore the pallet apart with a flat bar to get the the lumber in order.

Then he used the cross pieces which were 3.5inches wide and 1/2 to 3/4 inches thick. There was mix of oak (harder, longer lasting, heavier) & pine (softer, easier to work with lighter)

Then he cut off the split tips with the nails in them- to have clean, split free ends and not to bother with pulling out the nails.

Then he cut 2 pieces at 1ft long and 6pieces at 2ft long

He nailed 2 of the 2footers & 2 of 1footers into a rectangular box. The 2 footer edges over lapped the edges of the 1 footers. Unfortunately he moved so fast I didn’t get to photograph every step… but I hope you follow.

Then he nailed the remaining 4 2footers to the bottom of the box using 4d galvanized nails. These are rust resistant and small enough that they will keep the wood from splitting, but large enough to hold your box together when it is full of heavy, wet soil. Because the wood was irregular enough he just pushed the bottom slats together and nailed…but it is important to note during this step to leave a little space between the slats for water to drain out, but not soil. I usually stick a quarter between the slats which has always proven to be just right.

And there you have it. Here is one I made from Redwood and screws in 2010 (in front) and the new Pallet one (in back).

Similar—-but there are few subtle differences.

*The new one is a bit wider than the other. As far as size go, I pretty much try to maximize my table space. If you table is a 3×6 (which many tables are) you can fit 9 2×1 flats on it. That should be more than enough (much more in fact) for all your seedling needs. Remembering, when you start seeds in wooden planting flats you will need to divide them or thin them before they reach the garden, so leave space in you table(s) for transplants. This is basically bio-intensive gardening, but more on that later…here is the next step if you are eager.

*The other difference is that my new flat is mostly oak and the older one is Redwood. Both have their pros and cons

Oak- Hard, Heavy, Durable,Rot Resistant, Brittle-(Available in Pallets)

Pine- Soft, Not Rot resistant, Light weight, Cheap or free-(Available in Pallets)

Redwood- Light weight, doesn’t spilt easily, VERY Rot Resistant-(Must buy)

Wooden Flats are a great thing to add to your garden shed if you find yourself starting seeds every year. They are pretty simple to make, relatively cheap and last many years, not to mention they are NOT plastic. They work beautifully to hold moisture and give ample space for those babies to grow. Many farms use them, which is where I learned about them. Here are a few I stumble across while ambling through a sleepy farm in Colorado last spring.